10/3/2023 0 Comments Yabby gold hand dredge pump![]() ![]() (By not piercing the upper body of the Yabby, it should last longer) Going from the back of the Yabby go down 2 to 3 groves in its tail, and place the hook through the groove from the back to the front of the Yabby. There are three ways to put a Yabby on a hook that I use. ![]() The yabbies will get caught in the screen and you can wash away the excess sand/mud easily. If there is water over the area where you are pumping for Saltwater Yabbies, then you can use a sieve with a float around it, or an assistant holding the sieve to push the sand/mud into. ![]() With reasonable force, the sand/mud should spread out enough for you to see if there are any Yabbies in the extraction.ĭo the above 3 to 4 times in the same hole, until almost the full length of pipe is down the hole, then collect any of the Yabbies that were sucked out (extracted). Once you have the handle back as far as you comfortably can, pull the pipe out (holding the handle back still), once fully out of the hole push quickly the sand/mud out onto a flat area of ground nearby. This will suck the sand/mud into the pipe and allow the pipe to go deeper as you pull the handle back. Place the washer end of the pump into the sand/mud here and push towards the holes as you pull the handle back. To pump Yabbies, use a yabby pump (thank you captain obvious there).Ī pump is a metal tube with a handle at one end and a washer inside the tube at the other that creates suction when pulling the handle back.Īfter identifying the Yabby hole, you do not want to go vertically down the hole, but rather a few inches back and at an angle. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |